Hallway wall light fixtures are a way to light a room that saves space relative to a lamp, but avoids the lulls of roof lighting. These fixtures can be cheap or expensive, and they are always a kick to install. When tastefully chosen, they will beautify and improve all rooms. Use page separator to remove the final inch insulation of each of the threads of the light. Wrap the grounding cable around the earth screw in the cabinet.
Instructions
Take hallway wall light fixtures to the working area, where the wires hang on the wall. Place it over this area, be careful not to push the wires back into the wall and lose it. Check to see if it is level, and then select the attachment points. Put a hole in the wall with the nail, and then on the dry wall anchor with a rubber club. Unless your lighting weighs more than 50 pounds, and very few do, dry wall anchors will be sufficient to hold it. Turn off the power of the room at the fuse box / circuit box. Do not just leave the light switch off. Match neutral leads and positive cables to wires from the wall and as of the fixture together, and twist each set of copper wires together. Then cover them with plastic, screw-on cable connections. Fit the lighting by screwing it in place, using a screwdriver and anchors.
Tips and warnings
In the rare cases of a lighter heavier than 50 pounds, use molly bolts instead of plaster anchors. Replacing a hallway wall light fixtures takes some care because you are working with electrical wiring, but by taking the necessary precautions, you can install the chandelier correctly and without damage. Before you begin, make sure you tell others in the house what you will do to avoid touching the electrical box for the house. Installing a new chandelier should take you less than an hour to complete, even if it’s the first time you put one.
Turn off the power to the room on the electrical panel of the house. Plug a lamp into a socket in the room to make sure the power is turned off while working. Remove the screws that hold the old game order decorative cover to the roof and lower away from the roof cover. Remove the screws that hold the rib on the electric box in the ceiling and gently remove the old fixture. Attach the ribbon that came with the new lighting to the electric box by pushing the anchor screws through the belt and into the screw holes in the electrical box. Insert the threads of the new light through the nipple of the strap and the strap in the hood.
